The Rust Bullet® 패널(No.2), the Rust-oleum® Cold Galvanizing Compound 패널(No.5), the Wasser® Brand System 패널(No.6)과 POR-15® System 패널(No.8)은 3/16 인치 이하로 하부 컷팅한 선침선을 따라 부식된 것이 나타났다. 그러나 Rust-oleum® Rusty Metal Primer 패널(No.1), Rust-oleum® Rust Reformer 패널(No.3), Zynolyte Urethane with Zinc-Chromate Primer 패널(No.4), Naval Jelly® Rust Neutralizer 패널(No.7)과 Hammerite® Rust Cap 패널 (No. 9)은 각 패널 표면에 전반적으로 코팅이 실패한 것으로 보였다. 이 패널들은 완전히 실패한 것으로 판단되어 이후 실험에서 제외되었다. 대조용으로 코팅하지 않은 패널(No.10)은 너무 심하게 부식되어 더 이상 가치가 없어 역시 제거하였다.
Printed from :
National Testing Standards,I nc.,
“Test No. 3:
Method: After thermal cycling all ten test panels were placed in a salt fog/spray chamber for 500 hours (3 weeks). The chamber was operated in accordance with the procedures set forth in ASTM B-117 except actual sea water was used in place of standard salt water.
Results: Panel numbers 2, 5, 6, and 8 exhibited corrosion along the scribe line with undercutting of less than 3/16 of an inch. Panel numbers 1, 3, 4, 7, and 9 exhibited coating failure over the entire surface of each panel. These panels were considered complete failures and were eliminated from further testing. The uncoated control panel was so severely corroded as to be of no further value and was also eliminated.”(Report No.27935R2 National Testing Standards, Inc.)